When I measure a Point with the Portable Arm, the measurement is inaccurate. If I use the 15mm ball, I get an approximate error of 7.5mm. If I am using the 6mm ball, I get about a 3mm error. What is happening?
Ayr Location
2492 Cedar Creek Road, #4
Ayr, Ontario N0B 1E0
Phone: (905) 819-7878
1- 800-606-9266
Tech Tips
How do I Edit my Measuremind Program for Output to Smart
Report
1. Open your program in Measure-mind 3D.
2. Select "Part Setup" -> "Run Overrides".
3. Select the "Report Output" button.
4. In the "Overrides" dialog set the output to "Toleranced". (Note: you must have tolerance added to your dimensions for this selection to work.)
5. Set the "Sample Size" to 1.6. Set the "Report Type" to C:\OGP\SRPlus\Template\Onepiece.fst".(Note: Other report templates are available, the template above is for a single part)
7. Select the “OK” button to save this configuration.
8. Select "Close" to exit from the "Overrides" window.
9. Save your program.
10.Start Smart Report.
11.Run your program. At the end of the run your data should appear inside of Smart Report.
When I measure a Point with the Portable Arm, the measurement is inaccurate. If I use the 15mm ball, I get an approximate error of 7.5mm. If I am using the 6mm ball, I get about a 3mm error. What is happening?
