To send your measured results to Smart Report please do the following:
1. Setup the report template and sample size you wish to use by selecting "System" ->
"Configuration" -> "Output" from the pull down menu.
2. Now select the "Smart Report" tab from the "Configure Output" dialog.
3. From inside of the "Configure Output" dialog select the "Smart Report" tab.
4. Next, set the "Report Type" to "First Article", the "Report Filename" to "Onepiece.fst" and the "Sample size" to 1. Select the OK button to save these changes.
5.Measure or construct any feature that you wish to send to "Smart Report". From inside the measurement or construction dialog, set the output to "Smart Report" by choosing the Smart report icon in the list of output options.
6. Use the "Tolerances Tab" to set the appropriate Nominals and Tolerances for the feature.
7. Place a check mark next to each axis you wish to output.
8. Perform steps 5 through 7 for as many features as you wish to report.
9. Save and run your program and Smart Report will pop and display your results. | 
Shall I click on "CAD=PART" after I perform an "Iterative Alignment"?
