1.800.606.9266 Sales@CMMXYZ.com Support@CMMXYZ.com Training@CMMXYZ.com

PC-DMIS 2011 Release

Friday, 04.29.2011
PC-DMIS 2011 and PC-DMIS Planner 2011 have been released and are ready for download. Visit our PC-DMIS Support Page to download this new versions and read about the enhancements Visit our PC-DMIS Support page - click here
Contact Details CMM
Related Keywords PC-DMIS
Related Links http://www.cmmxyz.com/website/Software/PC~DMIS-Support.html
Hannes Rudolph 27 May 2011, 12:28 PM (EST) I recently had a job with a hole and a groove. I setup 2 tools eg T1 probe with 1mm tip & T2 with a 18mm disc. I first calibrate T1 as tool one & then T2 (the disc) as Tool 2. I calibrate T1 in DCC but T2 I had to calibrate manualy. Is tgere another way of doing it? Please review. Regards. Hannes. CMM 31 May 2011, 12:23 PM (EST) Yes, You have done the first part correctly with the 1mm probe. When attaching the disk probe the operator needs to constrain the probing angle to /- 5 degrees so that the calibration takes place on only the spherical portion of the disk probe. This can be done in DCC using a user defined calibration mode. Post your comments & new ideas here Your Name: Comment: Insert the code from above: